Cruise control plug&play
The connection is made on the gas pedal and on the speedometer (plug&play)
Scope of delivery:
- Ready-made cruise control in a plastic housing with all the necessary parts.
- Connection cable for connection to the speedometer and the accelerator pedal:
This dark gray lever from the smart 451 is intended for operating the on-board computer in vehicles that have an on-board computer installed.
However, it has the same technical structure as the cruise control lever from the smart 450, which unfortunately is no longer manufactured.
Only the color and lettering are different. It can therefore be easily installed to operate our cruise control. Both levers can be seen in the pictures accompanying this article.
All factory functions can still be used.
- PLEASE NOTE! -
For vehicles with an original on-board computer and for E-smarts, a switching cable is sent instead of a control lever, since the control lever of the on-board computer is used for both components!
Installation is also easily possible for non-professionals !!
Installation time approx. 40 minutes.
Security features:
- Automatic shutdown at :
- actuation of the foot brake
- Actuation of the handbrake
- Failure of the CAN BUS
- Failure of the speed signal
- With gear display N - 0 - R
- Opening a door while driving
- When the ESP intervenes
- Permanent check of the gas pedal
- (Toyota Effect)
Cruise control for smart for2 type 451 with the following functions:
1. Store current speed and hold
2. Save the speed as maximum speed
3. Increase current speed and hold
4. Decrease current speed and hold
5. Recall last saved speed.
6. Speed signal e.g. for navigation devicesg.
7. Accelerator pedal translation (better throttle response in the lower range (SpeedBooster)
